cyma loader bb 6mm upgrate

thingiverse

I'm tired of loading the loader. There are three types: from bottles like COLA; Evian bottles and wide-necked types (in my shop there were small juice bottles RICH which I really liked and served as a start for this project). Also, if you're able to work with STL, I'll lay out a basis (LOADER) on which you can design a carving necessary to you. Axial deviation I chose 10 degrees. To print rotate vertically (threaded to the table), turn on the support. To install, you must first remove the lid of the loader, to do this, unscrew (not to the end) the two screws, gently push the halves of the loader and remove the lid. Then there are two ways: the first: you insert instead of the cover into the pins upgrade for the loader and tighten the screws, ready (secure fit, pre-try the pins to the holes, if necessary, align with a knife or wire cutters). Second, after removing the cover, tighten the screws, take the upgrade things, cut off the pins and just click in the loader (not so hard hold, but quick disassembly). For the Russian segment: A wide mouth fits well from RICH juice, B.Y. Alexandrov's drinking yogurt, Palyi, and similar ones.