Cyclone_Water_Filter

thingiverse

This is a cyclone sand trap for plumbing, well pumps, garden pumps etc. Maximum working pressure 5 bar. The tank must be emptied periodically through the special vent hole by unscrewing the cap, the frequency of emptying depends on the quantity of sand in the water and on the duration of operation. For printing I recommend using good PETG. Another advice is not to expose it directly to sunlight or near heat sources, the material could deform and cause water leaks under pressure. The fittings and pipes must be screwed with the Teflon seal specific for plumbing systems, To couple the upper part to the cyclone it is necessary to put a 120 mm O-ring and use 4 m screws to tighten everything