cuty the dragon kid

prusaprinters

<p>Instruktion:</p><p>please print the testfile at first: all joints should be moveable without brute force.</p><p>If the joints not moveable scale the model up;</p><p>If the joints too loose, scale the model a little bit down.</p><p>0.5% or 1% up or down should be enough!</p><p><br>&nbsp;</p><p>Settings:</p><p>no raft, so support</p><p>I print the dragon 5° Celsius over the usual temeratur to get a good layer adhesion.</p><p>4 outer-, top- and bottom layers.</p><p>The best result I got with layerhigh from 0.16mm or lower but it works with 0.2mm too.</p><p>The first 20% of the print; I slow down the printspeed at 75% to manage the overhangs well.</p><p>Watch the testfile, depend on your printer and/or material you have to slow down the speed &nbsp;more at the first 20/25%.</p><p>After the print move carefully the joints, especially the neck on the bodyside(up and down) and the first joint of the tail are a little bit delicate.</p><p>On the neck there are two stop-points, so the first movement will be a little bit rough.<br>The tail has one stop-point.</p><p><br>&nbsp;</p><p><a href="https://youtu.be/S3cbYBbtMss">https://youtu.be/S3cbYBbtMss&nbsp;</a></p>