Customized Wave Lamp, Base, and Cap

thingiverse

I modified the original base that was uploaded earlier, which was an early revision, so it's likely that it didn't work for anyone who tried to print it. I've updated it now, and this is the correct version. I took the wave lamp base and adapted it to work with the LED strip that I had on hand, then created a cap to keep the whole thing together. The LED strip can be bought at Five Below (https://www.fivebelow.com/multicolor-led-light-strip.html). However, you'll need to trim one end of the strip in order for it to fit properly. I recommend printing the lamp section with glow-in-the-dark PLA filament. As for the cap and base, I think it's best to print them both with supports, but the wave lamp piece should be fine without any supports.