Customized spool holder for M3D printer 15.5mm rod

thingiverse

This object was made for use with rods that have an outer diameter of exactly fifteen point five millimeters. It is a customized version of a thing found at http://www.thingiverse.com/thing:731318. I am grateful to the person named evandepol, who made this design and posted it at http://www.thingiverse.com/evandepol. Here are the instructions: If you're going to use the following settings, then you will get the best results: the thickness of the wall is set at two, the height of the vertical walls is four, the horizontal walls have a wall thickness of exactly two point five. the diameter of the vertical rod must be precisely fifteen point five millimeters. in a similar fashion, the diameter of the horizontal rod should also measure out to exactly fifteen point five millimeters. the height of the cradle for supporting the object that is being held should stand at ten millimeters high, also make sure the length of the whole thing does not come in below twenty millimeters.