Customizable soda stream crystal bottle holder

thingiverse

**Customizable soda stream crystal bottle holder** Another Soda Stream (Crystal) bottle holder. I added several parameters - mainly because the one I printed for myself seams a bit to wide (I used 20 degrees angle). So I reduced the default angle to 7 degrees (while also 0 degrees are supported). That's why the image might look a bit different compared to the stl preview. For some of the parameters off course there are dependencies between them (that are not all automatically adapted in the scad file - I tried my best). For example if you change the offset between the 2 bottle holder circles, make sure the overall length is long enough. Some more hints for customization: * Do not set the offset lower than 52 - otherwise the bottles will collide. * I added the profile thickness parameter, but if this is set too small the upper circles will loose contact to the outer bars. So change the width accordingly. * It might be possible to remove the rear support. Anyway one bottle is above 600g - so it might bend too much - I didn't test that. * Personally I prefer the circular cap holder design, but I didn't print that, since it might need support. * Do not go lower than 110. Otherwise the bottles will touch the ground. * The drip tray is quite simple and poor. Please excuse that! Hints for the print: * Do not use the attached stl with both objects. I just added that for the preview. stl files for both separate objects are attached as well. * Print the holder upside down. At least with the non-circular side stands, there is no support needed. * Please expect a long print time of about 15h. * I used the default settings using PLA with 0.2mm layer height and 15% infill. I think less infill might be possible, but again consider the bottle weight (see above). Please feel free to create your own customization or modification. Any feedback is highly appreciated!