Customizable Shower Cubby Drain Tray

thingiverse

This is a fully customizable shower cubby tray designed for efficient soap bar drainage and enhanced ventilation behind shampoo bottles. To create your custom STL file for printing, edit the downloadable .scad file in OpenSCAD or click on the "*Open in Customizer*" link on this page to customize it according to your needs. If your cubby is larger than your printer's bed, you can print two or more parts to fit your cubby perfectly. You have full control over the dimensions of your shower cubby: The depth of the tray does not include the radius of the rounded nose, so the actual tray will extend an additional height/2 beyond the specified depth. You can specify a depth that is approximately 15% more than the actual depth of your cubby and still have the front feet within the cubby. This allows you to keep large shampoo bottles from sliding out and crashing to the shower floor, as long as you don't extend it so far that you constantly bump the tray. You can also adjust the height and thickness of each main "beam". A height of 10mm and a thickness of 2mm works well for most users. Note that the height is only for the main (front to back) beams, while optional feet, tails, and lips will add to the overall tray height. You can optionally add feet, a "tail", and a "lip" to your cubby tray: Feet are enabled by default and raise the overall tray off the cubby floor by height/2, aiding in drainage and ventilation underneath the tray. Tails are disabled by default and help keep shampoo bottles slightly forward from the rear cubby wall to aid in ventilation, but you lose a little useable depth in the process. Lips are disabled by default and are height/4 tall on the front edge, helping keep shampoo bottles from slipping off the front edge and crashing to the floor, but you lose a little useable depth in the process.