Customizable magnetic Flashforge Creator Pro Leveling Indicator holder

thingiverse

This is used to test the bed leveling of your Flashforge Creator Pro, which also makes it easy to check if your bed is flat, for example, after you install a PEI or BuildTak surface. Features: Magnetic Customizable and easy to tweak dimensions to match your printer's tolerances. No force is required when inserting the indicator. It is held by two M3 screws rather than being forced in place. Metal threaded inserts are used instead of applying force fitting it in. Here are the parts I built this with: Cylindrical (1/4 x 1/4) inches Cylinder Magnets made from neodymium. They can be found on ebay. 2 M3x10 screws A dial indictor, which I prefer metric over imperial because of its higher sensitivity (1 turn per mm vs 1 turn per 0.1") and 3D is done in metric units anyway. M3 thread heat inserts from McMaster http://www.mcmaster.com/#94180A333 . Insert with a hot iron and let the heat do the work. Don't push it too hard. Similar threaded inserts can be found on ebay but you will need to dremel one end to be conic as shown in the picture. Print Settings Printer: Flashforge Creator Pro Rafts: No Supports: No Resolution: 0.2mm Infill: 20% Notes: Material: Hatchbox Orange ABS Post-Printing Debarring the hole and long edges using a Shaviv debarring tool