customizable handle

thingiverse

A straightforward screw-mounting handle boasts through-hole and rounded ends. To print effectively, position it with the screw end downwards, eliminating support needs. A raft might be essential if your base width, radius, and hole dimensions lack ample surface area for platform adhesion. I managed to print one in PLA on blue tape sans raft. Remember to adjust screw_head, screw_shaft (add extra clearance), and screw_sink dimensions. The latter should not be too low to prevent weakness or too high for insufficient screw penetration. Resolution impacts outside curves; maintain a high value for smoother parts or experiment with lower values for faceted looks. If you prefer a flat bottom edge, use a slight bottom_radius (e.g., 0.1) but not zero.