Customizable FlashForge glass bed corner

thingiverse

Here are the corner pieces holding the glass in place. They provide an adjustment option since they're customizable in OpenSCAD. In the standard version, I modified one corner piece to fit my setup by removing nuts from bolts on the heated bed. A washer is added instead for better hold and less risk of the part sliding. Note: Using thinner glass may lead to damage if the plate overhangs. This isn't a major problem in X and Y because the design holds it in place without support needed in these areas. For Z axis movement, I trust gravity. I updated my script so both tabs work properly by using two corners instead of just one part attached to each corner piece. Note: Ensure that your bolts have the same spacing on opposite ends for this custom modification. To assemble this device print it in ABS and attach washers with no nuts over a washer and the bolts themselves. Make sure that parts butt up against glass when printing is completed. Instructions This project was made without support during printing and it looks like that could lead to difficulties when carving or refining your design, so try supporting during print instead and cut excess away later for clean surface