Customizable Drawer Organizer for Spice Jars

prusaprinters

<p>If you use a lot of spices placed in a drawer, you surely face the fact that whenever you close the drawer, the spices get jumbled. &nbsp;This system <strong>keeps spice jars in place</strong> and, thanks to its customizability, can be sized to ideally fill the drawer space.</p><p>The provided 3D models are ready for use with a flat-bottomed jar with a diameter 5 or 7 cm.</p><h4>Print Tips</h4><ul><li>0.3mm layer height (but of course, can be lower)</li><li>2 perimeters, 15% infill</li><li>no supports/rafts/brims</li><li>(tested with ABS)</li></ul><h4>Additional Material</h4><p>To connect the printed parts you will need<strong> 6mm-diameter rods</strong> (I used a hollow aluminium rod which is easy to cut)</p><ul><li>45 mm long for 7 cm jars</li><li>32 mm long for 5 cm jars.</li></ul><p>I recommend using good quality<strong> mounting tape </strong>to fix the parts to the bottom of a drawer. It is not necessary to fix all the parts, it is sufficient to fix the L-joint ones and the parts located in the centre of the grid.</p><p>If you're looking for the jars, I bought these:</p><ul><li><a href="https://www.aliexpress.com/item/1005002233188989.html?spm=2114.13010708.0.0.19574c4d8MnIYu">5cm jars (20 pcs)</a></li><li><a href="https://www.aliexpress.com/item/1005002751414320.html?spm=a2g0s.9042311.0.0.51b04c4dyZ94dj">7cm jars (10 pcs)</a></li></ul><h4>Note</h4><p>When fitting the rods into the printed parts, make sure that the rod is fully pressed into the hole, which is approximately 8 mm deep.<br>&nbsp;</p>