custom telecaster with arm rest cutout

thingiverse

HI! this is a custom telecaster I designed based off fender schematics, this print is designed to be printable on any ender 3 printer or larger. things of note - print the main body at 80%+ infill with 5+ walls to make sure the string tension doesn't cause warping (see the third photo to show how i oriented body) - print the rest of the parts with the side that would be in the back of the guitar down and at about 30-50% infill (they can be less as the string tension mainly goes through the main body) - all channels for wires, screw holes, and strings have already been modeled in, except for the holes used for the pick-guard, however extra material is modeled in where needed to allow the drilling of those holes - this guitar is designed around standard telecaster STRING THROUGH body bridge, meaning you need 6 telecaster (or really most guitar) string ferrules that are inserted in the back holes - my neck ended up being a little tight so i had to sand the neck pocket a little, however your mileage may vary - i attached the parts of the body using epoxy, - you should be able to print the whole guitar on just under two rolls of filament UPDATE -there are three new files under armrestcutout, middleuppercutout, and upperhorncutout. these files can replace their respective parts in order to have a guitar with a belly cut out as well as an armrest cut out required parts -telecaster style guitar neck (tuners, neck screws, back plate etc) -telecaster electronics hardware (standard two pickups and control plate) -telecaster pick guard (you can find files on here as-well) -6 string ferrules -drill(if a new neck you will need to drill the neck holes and also for the pick guard)