Custom Logo Hitch Cover

thingiverse

This hitch cover is a custom-made modification. I've adapted it to accept a 69 mm x 69 mm x 1.5 mm logo panel (the one I've included is also customized).\nSimply insert the logo panel from the top, and its three small clips will secure it in place. To change it out, just press on the logo panel from the back side at the top, slide it up, and remove it.\nThe logo panel should be 1.5 mm thick to fit snugly into the clips. You're free to design raised lettering and logos as you see fit!\nPrint Settings\nPrinter: Tevo Tarantula\nRafts: No\nSupports: Yes\nInfill: 10%\nNotes: These instructions were instrumental in two-tone printing:\nhttp://www.instructables.com/id/2-Tone-Printing/?ALLSTEPS\nSet your resolution so that an even layer will result in 1.5 mm for the logo panel.\nTo create your own logo panel, start with a 69x69x1.5mm cube and then draw your logo on top of it.