custom extruder mount for reprappro mono mendel

thingiverse

To prevent rubbing against the frame rods, I discovered that anything taller than 100mm would cause my bowden tube and wires to get caught. Therefore, I created a custom mount that elevates and rotates the extruder drive 90 degrees, placing it above the left Z motor. Now, the tube and wires run between the upper frame rods without any interference. This modification also allows for maximum height reach. Printed in ABS at 0.3mm layers with three shells and 40% infill, this mount requires four M3 x 20mm bolts, nuts, and washers (optional). Extruder attachment uses two M3 x 25mm bolts and nuts. Unfortunately, there are no pictures yet due to my camera's malfunction.