Custom Case for ICE Project

prusaprinters

Case which is compatible with either the 6502, 6809 or Z-80 ICE project here. https://github.com/hoglet67/AtomBusMon/wikiThese cases are for the EEPIZZA (rella-engineering) FPGA board using Dave's Level Shifter PCB's documented above. This case will not work for the GODIL build.The top part of the case is generic for all 3 CPU's… the colored nameplate can be printed in any color and you need to add a color change at 0.8mm to black.The bottom of the case is the same for the 6809/Z-80 but the 6502 is different as it has 4 triggger/config connectors.For the buttons, you will need two. I printed RED for the reset and YELLOW for the interrupt. There is also a 3 led LENS but you may or may not want to use this. If you haven't already soldered in your LEDS, then you might want to bend them 90 degrees as they should fit right out through the side of the case which would look the best.PS - My bench is a mess, don't judge me! :-)