curtain rod holder

thingiverse

Replacement for bad/useless curtain rod holders. ===================================== This one has a hole all the way through for easy access to the screw for mounting and a locking piece that goes over the rod to hold it in place. Made for 11mm diameter curtain rod, but the hole is actually 12mm, making it suitable for anything below that size. The lock.stl parts might need scaling depending on the dimensional accuracy of your printer. They work as is with mine. 3 (+1) versions: ---------------------- ### Round to be printed standing on the flat bottom (top when hanging) curtain_rod_holder.stl curtain_rod_lock.stl Same but with builtin support, after printing, hit it with the pointy end of a hammer on the support piece in the direction it can slide out. It should come loose and leave a nice surface. There is a 0.2mm gap between the support piece and the rest. Your results may vary depending on printer and filament. curtain_rod_holder_builtin_support.stl ### Version 2 is square: To be printed on the back and no supports should be needed. curtain_rod_holder_v2.stl curtain_rod_lock_v2.stl ### Version 3 is almost round, just with a flat backside to be able to print it laying down as not to need supports. curtain_rod_holder_v3.stl curtain_rod_lock_v3.stl I printed mine in PLA on a Prusa MK2s. Assembly: If you need instructions, this is definitely not a job for you.