Curtain Rail Slider and Clip

thingiverse

I have an interesting double rail curtain rod with rolling sliders in my living room that I could not find hardware for. So, I decided to make my own. Each of these that you want to print will require an m4 nut and bolt (16mm). There is a channel in the body of the roller to slot the nut into and the m4 bolt will hold the clip in to the roller. I altered [sparr's](https://www.thingiverse.com/sparr) [Curtain Clip](https://www.thingiverse.com/thing:14946) for the piece that hangs down to hold the curtain itself. You will want to print with supports on the roller itself and potentially use a brim if you run into bed adhesion issues due to the low amount of model touching the bed itself. I found that linear supports worked better on this model than tree supports as well.