Curling iron holder outlet cover

thingiverse

This holder was designed specifically for the Vivid and Vogue Auto winding curling iron, as shown in the picture. The outlet cover used was borrowed from this link: https://www.thingiverse.com/thing:246532 - a great printing model. The inside diameter of the holder ring is 58mm with a 38mm opening. This project was completed quickly and somewhat carelessly, resulting in imperfections that are hardly noticeable when viewed on the wall. By "imperfect," I mean that some shapes added to form the ring may protrude through the underside of the cover slightly. These minor issues were not cleaned up because they seemed insignificant. The holder appears strong with a 20% infill setting, but if I were to redo it, I would likely increase the infill percentage for added durability. With only one screw holding it to the outlet, the holder can seem somewhat floppy at times, but it has held up so far. To print this model successfully, lay the cover down flat on its back and use supports. This holder was a lifesaver in our small kids' bathroom, where space is limited.