Cupholder for BMW E90

thingiverse

I was on the hunt for a custom cupholder that would perfectly fit my BMW E90 tray, but nothing seemed quite right - everything I found was just too big. After some tinkering, I managed to design three versions of a cupholder that fit seamlessly into the tray without any obtrusive navigation or iDrive knob. These designs accommodate 250ml, 330ml, and 500ml cans (perfect for Germany/EU). While the largest design does work, it's worth noting that the walls might become a bit too thin to hold up under stress. I use this cupholder every day and can confidently say it fits like a glove into the tray. This design was specifically tailored to be printed with PLA filament; if you're using ABS, you may need to upscale it slightly to achieve the best results. One additional benefit of this design is that it can be printed on a flat surface without the need for supports - just stick a tag on and you're good to go. If you enjoy the design, consider leaving a small tip as a gesture of appreciation. **Update 27.06.20** A user requested a wider hole (currently 57mm) to accommodate Norwegian 500ml cans. In response, I uploaded an updated version with a 66mm hole. However, please be aware that the walls may become quite thin and prone to breaking - I won't be attempting this myself. **Update 11.07.20** While shopping for a German/EU 330ml can, I realized it wouldn't fit in my existing design. So, I took the opportunity to slightly widen the hole (to 59mm) to accommodate these cans as well. Enjoy!