Cup/Cup holder (read directions)

thingiverse

This is a custom cup holder I designed, or rather a versatile holder that can accommodate any size vessel you prefer. Simply scale up its dimensions by approximately 2.5 times to perfectly fit a Nike water bottle. Created in 123Design, this project features the following print settings: Printer: Whanaho Duplicator I3 Rafts: Not required Supports: None needed Resolution: A 1mm layer height ensures crisp details and smooth surfaces. Infill: To optimize printing time without compromising structural integrity, I used a moderate 50% infill density. However, you can adjust this setting according to your desired level of part strength. To achieve optimal print quality, follow these custom directions: Print on a glass bed using a disappearing purple Elmer's glue stick for adhesion. This specialized adhesive evaporates when the bed temperature exceeds 50°C, allowing for effortless removal. Begin printing at regular speed for the initial layers and then switch to a faster rate of 250mm/s for the final few layers.