CTC Upper Corner Fillers - Case Upgrades

thingiverse

These corners are compatible with the black CTC (dual) printer, specifically the version where the lowest side panel screws are positioned 25mm above the table surface. The installation process is straightforward; simply remove two screws from the side panel and replace them with these corners. This addition provides stability to your printer by reinforcing its frame. Additionally, you only require side and front windows along with a hood to prepare for ABS prints. These corners do not interfere with the drive linkage. You need two of each type, and if printed correctly without rafts or supports, they can be easily attached. However, printing these corners may pose a challenge due to overhangs and sharp edges, requiring precise matching of profiles according to your filament and printer. ABS and PLA work well with varying infill densities. For low infill rates, increase the number of shells to ensure adequate material beneath the screws. Successful printing results in attractive corners for your printer.