CTC - Netzteil - 80 und 60 mm Lüfteraufnahme

thingiverse

Here's a step-by-step guide to installing an 80mm fan in the CTC power supply and similar models. It's essential to note that you'll need adjustable feet to ensure the power supply has enough clearance from the surface area. Check out my adjustable feet on the images provided; I'll upload them later if needed. The original screws holding the cover to the case have been replaced with M3x8 or M3x10 screws, along with a washer each time. You can see this in the second and fourth image. When installing the screws, make sure none of them protrude too far into the case. I've installed an 80x80x10mm / 24V / 2Pin fan, but a 15mm high fan should also fit. However, it's always best to double-check before installation. If you decide to go back to using a 60mm fan in the future, you can print out the 60mm adapter, which has the same outer dimensions as the 80mm adapter but is designed for a 60mm fan. Pitsch3D has created a YouTube video about this topic; make sure to watch it.