CTC Druckbett Nivellieren Messuhraufnahme

thingiverse

I drew and printed this piece to check the alignment of the print bed. It can be clipped onto the X axis guides (8mm rods) and a dial with an 8mm shaft inserted. The holder can be manually adjusted to measure the entire surface area of the table. The optional side hole was intended for threading a screw to secure the dial, but it's tight enough that I didn't need to use it... I designed it at 3mm thickness and after drilling to 3.3mm, an M4 screw should fit perfectly. I intentionally positioned the dial further left because I had planned to use longer M5 plastic screws...\nPrinted with 20% infill and 0.25 layer thickness.