Crown Valyrian II Replacement Tank

thingiverse

I only had to provide support at the top curve, so my support bases should be inside the tank itself. The outside contours print beautifully without any need for supports whatsoever. I printed at extremely low speeds - a mere 15 mm/s for printing and 20 mm/s for travel - in order to achieve a more transparent final result. I'm well aware that this is a very specific tank, but if you're able to measure whatever you may have on hand, you should be able to scale this to fit most any tank with some trial and error. To give you a better idea of the size, my model is 101.5% (in both x and y axes) larger than my initial measurements, which means there was some room for tolerance in order to fit snugly around the O-rings without being too tight to install. This tank happens to be slightly larger than what's needed for a Crown IV, just so you know. All Crown models seem to require slightly different sizes, after all.