Crossing segment and 2-Strips clip for Easy-to-print Led Bridge with Light block

thingiverse

There are two parts in this : 1- Crossing top segment (to joint two bridges) 2- Clip to hold up to 2 led strip without having to use 3M tape 1- Crossing segment This is a crossing segment part that goes at the top of the bridge so you can have two led bridges crossing each over. The angle between them will be 45 degrees, so you'll loose a little bit of work width under them but get more light. I didn't printed it yet though. When printing, if you want to print it vertically, be sure to get the right angle so you'll have a raft under each "leg". At the actual angle, you won't. I guess it's possible to print it horizontally also, however it'll sure require more supports and the finition will differ from the other parts since orientation of printing won't be the same. Anyhow, like I wrote, I didn't try it yet, so if anybody has already 2 bridges printed and want to give it a try, please give feedback, comments or makes pictures. 2- Clip It is a clip to hold the led strip instead of having to tape it with double-faced tape (or other). It's stick by friction inside the slot already there and add anoter space to support a second led strip (more light). However, the second led strip hide a little bit less behind the light block, it's still useful if you want two strips with that bridge. *** Well, the heat from the led light deforms the clips and they start falling after a while. I've printed them in PLA. I guess it will be better in PETG or ABS ***