Crossbow for match V2 / Crossbow for match V2

cults3d

Crossbow for match V2 Here is a crossbow for match. After cleaning the parts. It takes elastic, which must go through the holes of the bow and go around the loop to stretch it. Slipped this one under the body of the crossbow. Clip the trolley over the body and move the top elastic over and under which will balance the thrust. Pressing both ears releases the trolley and propels the match The dimensions of the assembled crossbow are: Length = 7.31cm, Width = 7,7 cm, Height = 8.04 cm Enjoy the game. Layer thickness 0.2 Hull thickness 1 Fill rate 30 Temperature of 220C ° printing Media Type all over Crossbow for match V2 Here is a crossbow for match. After cleaning the parts. You need a rubber band, which you have to pass through the holes in the bow and go around the loop to tighten it. Nailed this one under the body of the crossbow. Clip the carriage on the body and run the rubber band up and down which will balance the thrust. A pressure on the 2 ears releases the carriage and propels the match The dimensions of the assembled crossbow are: length = 7.31cm, width = 7.7 cm, height = 8.04 cm Good part. Layer thickness 0.2 Hull thickness 1 Filling rate 25 Printing temperature 220C°. Media type all over