Crosman Skeletal Stock Riser

thingiverse

This is a 1.5" riser for the above mentioned stock. Print with the X axis at 122.5mm, all else "uniform scaling". The file "CrosmanRiserNoSlopeV17d" uses double-sided tape to secure it to the stock(3M Outdoor). The channel is wider to accommodate the tape. Gently spread the sides as you seat it on the tape to get the best seating depth. The file "CrosmanRiserSlopedChannelV15bScrew" is mounted with screws 3" on center(verify). Drilling the stock will be required. The screw holes are 1" deep. The channel is 2 degrees per side narrower to fit tighter. The riser is ALSO SLOPED to fit the stock better so the taller side goes to the rear. I've included the Designspark Mec. original file so you can tweak it if you desire; I'm making changes to refine these as time permits.