Crobe - RC Glider

thingiverse

#CROBE - RC GLIDER Small pitcheron slope soarer based on original design, made from balsa wood, designed by Franck Aguerre, described at http://lecrobe.free.fr. ## REQUIREMENTS - Two servos like D05010 / DSM44 - Lipo 1S battery with a capacity of 300 - 400mAh - Small receiver - Main carbon rod diameter is 3mm - Elevator made from 1.5mm balsa wood - Small parts, including PVC tube with a diameter of 2/1mm and steel rod with a diameter of 0.8mm - RTF weight: 109 grams ## PRINT - Approximately 80-90 grams of PLA+ - Layer height: 0.2mm for fuselage and wings, and 0.15mm for canopy - No support required, just some brim - No infill - One 0.4mm wall - Maximum print height: 170mm - Layers are 0.12mm thick and line width is 0.3mm for 'Light' versions of wings - 'Flat' wing means without dihedral, like the original balsa's Crobe. ## RC settings - Delta mixer - Elevator function: +/-6mm (measured at trailing edge / wing root) - Aileron function: +/-4mm - CG is balanced with fingers located on both PVC tube (used to maintain wing with rubber band). ## UPDATES - 24/03/2020: Initial upload (v0.1) - 25/03/2020: Small fix for Part3 - Add flat wing version (like original) - 27/03/2020: Maiden flight - Flat and Light wing versions - Small fixes - 28/03/2020: Updated canopy - 13/08/2020: Canopy with lock - Removable stabilizer with screws (v0.11) - 19/09/2020: Fuselage part1 (v0.11) with reinforcement against wing punching