Crimper Pegboard Holder Mk1

thingiverse

This Customized Version is Generated From http://www.thingiverse.com/thing:537516 Using the Following Parameters Set by You! The Thing was Created with Our Customizer at http://www.thingiverse.com/apps/customizer/run?thing_id=537516! Instructions to Build it: Using the Below Options, Please Note That You Can Adjust Them as Per Your Requirements. Holder Angle is Set at 0.0 Degrees. Holder X Count Has Been Set to a Value of 1. The Taper Ratio is Currently at 1.0. Holder Y Count Is Fixed at 1 Unit. The Offset Value for Holder Is Kept at 0.0. Corner Radius has been Fixed at 30 Units. The X Size for the Holder Comes In At 80 Units. A Standard Height of 15 Units Has Been Maintained for the Holder. A Value of 0.0 Has Been Selected for Closed Bottom Feature. Wall Thickness Is Currently Set to 1.85 Units. The Strength Factor Stands at a Decent Value of 0.66. Holder Y Size is Measured At 20 Units, Making it an Excellent Size for Most Users. Since You Didn't Opt For Any Special Holder Cutouts on the Side, the Feature Has Been Removed By Setting Its Value to 0.0.