Credit Card Cup Conserver

thingiverse

This project was undertaken to prevent the paper cup of coffee from sliding off the tables in the lecture hall, which are angled at 9 degrees. To utilize it, the 'hook' on the sliding part must be placed behind the front edge of the sloped table, allowing the feet to rest on the table, beneath the hook. The assembly should be quite straightforward. Originally, the sliding part was intended to adjust for the angle of the table, but it appears to have little impact. Initially, a bulky version was created, so I decided to slim it down to fit inside a wallet. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: No Resolution: 0.1 mm Infill: 100% Notes: I wanted a dense piece of plastic to wave around, but a lower infill might also be sufficient. I don't believe a higher z-axis resolution than 0.1 mm would be effective, but it could be worth trying.