CreatorPro Z Axis Offset

thingiverse

This part connects the CreatorPro z-axis limit switch when installed, providing a 0.27" offset that allows for easy installation of the FlashForge 0.25" glass bed plate. Print Settings: Printer: FlashForge CreatorPro Rafts: Doesn't Matter Supports: Yes Resolution: 0.2 mm Infill: 100% Notes: I chose to print this part with the long surface facing vertically (along Z), which is why a small tab was added. Post-Printing Installation The part gets installed by removing the 2 M3 cap screws holding the FlashForge logo plate in place, as indicated by red arrows in figure 1. Replace these screws to secure the part firmly in its new position, as shown in figures 2 and 3. Use manual jog controls to verify proper limit switch contact and ensure clearance from mounting screws and the PC board, as depicted in figure 4. Next, install and level the glass bed, using binder clips if needed, as indicated by yellow arrows in figure 1. Figure 1 Figure 2 Figure 3 Figure 4 How I Designed This This is an original design created with SolidWorks, drawing inspiration from the innovative work of 3DPrinterNinja (www.thingiverse.com/thing:976727).