Creality3D Ender series high flow ring vent (Remix: 0.5 thru 2.5 mm lower)

thingiverse

On my Ender-5, this one works flawlessly! Thanks go out to Wacio for making it happen! The Ender-3 poses a challenge with its vent touching the heater-block. To solve this issue, I created two new versions of the vent, each with a 1 and 2 mm higher top-part. To determine which print to use, follow these steps: Measure from bed to the underside of the part-fan without any shroud. Subtract 13.46 mm, which is the total height of the original vent. Then subtract 0.75 mm for the desired tolerance. The resulting number will indicate which variant to print. My measurement yielded 15.7, giving me a result of 1.49. Therefore, I opted for the 1.5 mm variant. If you require a higher or in-between version, just let me know! Edit: I mistakenly marked the wrong original vent as remixed. This is actually a remix based on Wacio's part cooling vent, #3345351. Edit: I've added the exact numbers calculated by TinkerCad for reference.