Creality Spool Holder Retainer Nut

thingiverse

I downloaded the Ender-3 Dual Spool Holder design from Goscicki. Upon inspecting it, I discovered that Creality had updated their Retainer nut at some point. After searching online, I could only find printable versions of the outdated 30mm hex nuts I already possessed.\r\nSo I created this replacement.\r\n\r\nIt's a snug fit for me, but the spool holder I printed was slightly warped.\r\n\r\nI suggest using supports. It may print without them, but the tolerances are precise so warping might be too much. Also, the supports on this model are very small.