Creality LD-002R Angle Double Angle Build Plate Drain

thingiverse

This is an add-on designed to facilitate efficient resin drainage from the Creality LD-002r printer's build plate (and model) following a print.\r\n\r\nAlternative designs often feature a single angled surface, rotating around the y-axis, which tends to collect resin on the downward edge and within the bracket's "pocket." To improve drainage efficiency, I designed this add-on with two axes tilt capability, allowing the build plate to drain towards a designated point.\r\n\r\nBy tilting the build plate in both axes, it moves closer to the front of the printer, so this version shifts the build plate further back. This adjustment enables users to put the printer cover back on while draining the resin, protecting the vat's contents. However, taller prints may still collide with the cover, requiring careful placement.\r\n\r\nWith this design, part of the build plate extends beyond the vat, risking resin drips onto the printer. To mitigate this risk, I suggest placing a folded piece of paper towel under the front cover to shield the printer between the vat and the cover's edge (refer to photos).\r\n\r\nThis add-on is listed as a remix because it was designed by measuring and borrowing from existing designs, with significant modifications made in Fusion 360. A screw hole was not included where the build plate attaches, as experience has shown this design to be stable and secure without additional fastening.