CREALITY K1 + K1C HONEYCOMB STORAGE WALL (STANDARD) (UPDATE)

prusaprinters

*If you have any issues with printing or assembly, feel free to message me, and I'll do my best to assist you 😉. /////ATENTIONThanks Dirkw@Dirkw_2123163 for this info:“Just a warning to all the owners out there. If your screws are a bit too long it can pinch wires and screw with the bed leveling. The wires seem to be in the upper left on the left side. Just be careful.“Before starting printing the pieces, I recommend printing this tool https://www.printables.com/model/899470-xyz-accuracy-test-calibration-tool to test the dimensional accuracy of your printers and use this tool https://www.printables.com/model/480907-shrinkage-calculator-dimensional-calibration-tool to determine the correct scale based on the filament shrinkage you’ll be using.The pieces were developed with very tight tolerances (0.2mm) to ensure proper alignment and functionality of the assembly, so it’s important to make sure everything is well-calibrated or that you understand what is needed for everything to work correctly.USE THE PDF FILE TO TEST THE DIMENSIONSFor the supports, I recommend using these settings (ORCASLICER):Top Z distance to [0.1mm] in the Support TabSupport Interface Fan Speed to [15%] under Cooling in the Filament settings. /////DESCRIPTIONHONEYCOMB STORAGE WALL (STANDARD) FOR CREALITY K1 + K1C The right side wall comes in two models: 1st - Same as the left side. 2nd - Includes support for the spool and sensor.The central cover can be customized (STEP file included).The pieces are attached to the printer with M3x10mm screws (see image).All pieces are numbered on the longest side (see image).Installation is done in numerical order for each piece. The first piece to be installed is the bottom left piece. Do not fully tighten the screws until all pieces are installed and pre-screwed. The screws removed from the printer can be used to secure the pieces together. /////BOM to print LEFT SIDE: K1_K1C_HONEYCOMB_LEFT_WALL.zip1 x LEFT_HONEYCOMB_1_V21 x LEFT_HONEYCOMB_2_V21 x LEFT_HONEYCOMB_3_V21 x LEFT_HONEYCOMB_4_V21 x COVER_STANDARD_1 (customizable)2 x COVER_STANDARD_2 /////BOM to print RIGHT SIDE: K1_K1C_HONEYCOMB_RIGHT_WALL.zip1 x RIGHT_HONEYCOMB_1_V21 x RIGHT_HONEYCOMB_2_V21 x RIGHT_HONEYCOMB_3_V21 x RIGHT_HONEYCOMB_4_V21 x COVER_STANDARD_1 (customizable)2 x COVER_STANDARD_2 /////BOM to print RIGHT SIDE wiht SPOOL and SENSOR: K1_K1C_HONEYCOMB_RIGHT_WALL_V2_SPOOL.zip1 x RIGHT_HONEYCOMB_1_V2_SPOOL1 x RIGHT_HONEYCOMB_2_V2_SPOOL1 x RIGHT_HONEYCOMB_3_V2_SPOOL1 x RIGHT_HONEYCOMB_4_V21 x COVER_STANDARD_1 (customizable)2 x COVER_STANDARD_2