Creality Halot One Fan Duct

thingiverse

This is a fan duct for the Creality Halot One. It is designed to fit a Noctua NF-A8 FLX fan with a 2 1/2" duct. I used Peachtree 2 1/2" x 10' Clean PVC Dust Collection Hose for my duct. The Noctua fan had the wiring routed through one of the vent holes on the back of the Halot One then connected to the fan header for the internal fan with a buck converter to get it down to 12V. The duct is printed in the orientation the model is. make sure to use supports. I attached the duct with some double sided tape and two of the original mounting holes on the back of the Halot One. I included 1 additional screw mount if you would prefer to drill a hole into the Halot One. I did not see a need with the double sided tape. I am uploading this well after I installed it but I believe I needed longer screws to mount it.