Creality Ender Unitak3d LED Light Bar Mount

thingiverse

I purchased a Unitak3d 24v LED Light Bar for Ender 3 V2/Neo, Ender 3 Pro,Ender 3/Neo,Ender 3 S1, Ender 3 Max,CR6 SE 2020 https://www.amazon.com/UniTak3D-Printer-Embedded-Upgrade-Creality/dp/B0B3X9CKWW I like the light as it is 24v and very easy to wire but it mounts on the underside of the top 20x20 v-slot beam and when lit shines directly down on the Z-Axis and casts a shadow. I decided to either design or find a mount that would kick it out from the beam and shine down at an angle. I found https://www.thingiverse.com/thing:3118671 by xxMonkeyxx and liked it so decided to use it for only the brackets which I edited in the following ways; - Added wire clips to one of them for wire management - Added holes for the Unitak3d On/Off Switch Bracket (https://www.thingiverse.com/thing:5384261), slightly edited - Changed the light bar end to fit my bar design The light bar holder/beam I more or less designed from scratch using 20x20 v-slot dimensions as a starting point. The hardware you will need to build and mount are as follows: - 2 M3 x 16 bolts, I used round head - 2 M3 x 10 bolts, I used round head - 4 M3 V-Slot T-Nuts - 2 #4 1/4" Screws to mount the switch bracket - 2 #4 5/8" Screws to mount the Bar/Beam to the Brackets * Note most holes are present for the hardware except for the holes in the brackets for the Bar/Beam due to the fact everyone's setup might not be the same and warrant adjusting. It was easy to mark them with the bar itself and drill them by hand.