Creality Ender 5 E3D Hemera Mount

myminifactory

Hello makers, I built this Hemera Adapter specifically for my Ender 5 printer. Initially, the first versions fit snugly, so I made some minor adjustments to make it easier to install. To assemble it correctly, rotate the upper screws and inspect your limit switch on the right-hand side. It needs to be adjusted inward by a few millimeters to prevent the Hemera from colliding with the printer's home position. My goal was to design an adapter that uses minimal space while maintaining stiffness and using as little material as possible. The nozzle should sit at the same spot as the original one. Here are two versions: Version 1 features a blue Hemera adapter, and Version 2 adds a cable guide in grey. This comparison shot shows how it looks when the Hemera is attached to the mount. Keep in mind that I haven't tested this thoroughly yet, so please reach out if anything doesn't seem right. After my initial test fit, it appears very promising - tight and with no play. Since many people have been asking for a solution like this, I decided to share my design before conducting further testing.