Creality Ender 3 Pro- Dual Double Drawers

thingiverse

Edit: 5/15/20 Added empty upper and lower right side drawers. If you need them on the left, just mirror in your slicer. Edit: 8/30/2019 The two cases were too tight, so I reduced one edge width from the cases and bottom drawers for a better fit under the Z rail. I moved my Main Board and Raspberry Pi to the back of my Ender 3 Pro with a remix of Teaching Tech's rear case. This left me with plenty of room in the front for storage. This gave me the space I needed to add two drawers side-by-side. Remixing required narrowing the case to 125mm wide, narrowing the bottom drawer to match, and re-centering the bottom drawer handle. I then mirrored the right side in Tinkercad to make it easy to print the left side without any modification. Orientate on the print bed according to the original instructions.