Creality Ender 3 Power Supply (PSU) Wall Mount

thingiverse

9/9/18 Edit: I'll adjust the tolerances for the bolt pattern. Hold off on printing for now; I'll remove this note once I make the changes (probably in about a week). Here's a quick model I whipped up in Sketchup that uses existing Ender 3 PSU mounting patterns. WARNING: Be sure to use a flush-mount screw of suitable length when attaching this to the power supply. If your screws are too long and protrude into the power supply, you risk shorting it out. Use good judgment and common sense - only you will be held accountable if you ignore this warning. This power supply isn't excessively heavy or prone to overheating, so PLA should work just fine.