CREALITY CR10S PRO SPOOL HOLDER WITH BEARING

thingiverse

Here's my design for a spool holder with bearing or not that I created for my Creality CR10S Pro using Fusion 360 to bring this project to life. To mount the spool holder on your printer frame, you'll need: * 3 x M4 x 8mm screws and T-nuts for version V1 * 4 x M4 x 8mm screws and T-nuts for version V2 ARM_BEARING_CR_V2 and ARM_BEARING_CR_V2.1 have the same design, but with different lengths. Both feature a main shaft with a bearing at the end. The ARM_BEARING_CR design has bearings sitting on pins. To pair your spool holder with the right arm, follow these guidelines: * SHAFT_BEARING_CR_V2.1 pairs with ARM_BEARING_CR_V2.1 (compatible with 72mm spool width max) * SHAFT_BEARING_CR_V2 pairs with ARM_BEARING_CR_V2 (compatible with 87mm spool width max) * PIN_BEARING_5MM pairs with ARM_BEARING_CR (single version, compatible with 77mm spool width max) * arm without bearing (short version: 77mm spool width max) * arm_long without bearing (long version: 87mm spool width max) For the arm with bearing, use R1450ZZ or 605ZZ Shielded Ball Bearing. The specs are: * inner diameter: 5mm * outer diameter: 14mm * width: 5mm Check out this link for the Filament Guide: https://www.thingiverse.com/thing:4317259 Note that "plain" means no logo, and "XS" means a stronger version.