Creality Cr10s Dual extruder upgrade

thingiverse

A upgrade for the Creality Cr10s printer to get dual extruders. Printing: Infill - 20% layer height - 0.2mm outer layers - 4 This print is based around the standard creality 12V extruder like this one: https://www.amazon.nl/gp/product/B08BJ22WN1/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 This print also makes use of m3 brass inserts with a length of 3mm, most holes will also fit with 4.5mm length inserts, but not sure if all will I have not tested that fully. A (more) 3D printable version will be here soon, so no inserts will be needed for that future one, will also be linked here when finished. A quick guide on how to assemble, wire and setup will also be linked here in the near future. Any recommendations or remarks are very welcome as I hope to improve this design as much a possible!