Creality CR-8 Fan Duct

prusaprinters

<p>This is for ----<strong>Creality CR-8 / Afinibot A9 ----</strong></p> <p>I tried to make it as lightweight and small as possible, about 16 grams of plastic (100% infill).</p> <p>It uses a 40mm x 40mm x 20mm 4020 Blower Fan... <a href="http://www.ebay.com/itm/322387076538/">See LINK</a></p> <p>It is a screwless design which slides onto the Housing of the hotend fan.</p> <p>(The screws of the hotend fan housing must be loosened to slide it over though)</p> <p>The blower is press fitted in to the fan duct housing, screw holes are just optional.</p> <p><strong>Remember</strong> to slide the fan duct far enough in, so that the blower fan does not interfer with the bolts at the X endstop</p> <p>See my other things <a href="/Jubaz/designs/">HERE</a></p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Creality CR-8</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div> <p><strong>Infill:</strong></p> <p>100</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Notes:<br/> If you slice it with Simplify 3D and you have missing support, try lowering your "Support pillar resolution" or just add custom support. <p>I used Simplify 3D ´s default support (4mm pillars) and then added some small custom support for the overhang part that where missing.</p> </p></div></p></p> Category: 3D Printer Extruders