Creality CR-6 SE RPi 4b+Hat V-Mount Case

thingiverse

I want to automatically power my RPi up and down automatically with the CR-6's power switch. To that end, I'm getting power from a spare 24V rail off the CR-6's PSU, using a LM2596 step-down module to output 5V, and a UPS hat with a small battery that triggers a graceful shutdown of the RPi when power is cut. Malolo's case was a fantastic starting point, but I wanted it mounted out of the way on the v-rails. I also liked the PiCam mount from https://www.thingiverse.com/thing:4650151, and the photo shows that being used as well. All I did was raise the standoffs in the top to accommodate the UPS hat, add v-slot mounts, and lastly a mounting point for the camera mast. You can print the standoffs or just use any standard 12mm RPi hat standoffs. Print the top using bed supports for the v-rail mounts. No supports needed for anything else.