Creality CR-6 SE Rear Cable Bumper

prusaprinters

<p>The cable for the heated bed on my CR-6 SE was catching on a corner of the Z-stepper motor. When the bed moved forward, the cable would get caught on the edge of the motor and scuff.</p><p>This bumper slides over the Z-stepper motor and provides a seamless edge for the cable to slide against, while also softening the angle at the corner. Since adding it, I haven't noticed any more scuffs in my cable.</p><p>I had to modify the design after I replaced the plastic spacers under my CR-6 SE's bed with silicone mounts, which caused the bed to sit slightly lower and rub against the cable bumper. To fix this, I flattened the top of the bumper so that it only rises 1mm above the motor and provides maximum clearance.</p>