Creality CR 6 SE Part Cooling 40mm remix

thingiverse

Remix to: * Make it more recessed so that the part cooling is more aligned with the nozzle * Go _over_ the screw that was in the way, rather than around it, to allow for https://www.thingiverse.com/thing:4654645 to be used with it unmodified Print it vertically. There's an orientation that requires no supports. It's not much stronger than the one it's remixed from , so if that's what you're looking for then this one combines the cable/bowden clip with it: https://www.thingiverse.com/thing:4763949 (but does make it harder to disassemble presumably).