Creality CR-6 SE Cable Support with PTFE clamp

thingiverse

Remix of Sidewayz_Control's [Cable support for the Creality CR-6 SE](https://www.thingiverse.com/thing:4654645). Also fits the CR6-SE Max, as reported by [Tchunass](https://www.thingiverse.com/tchunass/designs) in the comments - thanks! The cable support itself is remixed to add a clamp for the PTFE tube. The strain gauge sensor can be triggered by the PTFE tube pulling up on the hot end, which occurs if the gauge is zero'ed e.g. in the middle of the bed or to the right, and the hot end is then moved to the far left. Controlling the printer via the touch screen generally avoids this issue as it forces homing (which re-zeros the strain gauge) prior to actions like bed levelling - but when driven from elsewhere (e.g. Octoprint) it can often be a problem. The second model is a replacement for the X Axis limit switch and belt drive cover. Sidewayz_Control's piece is a slide-on outer cover, but I found that could slide off and could also get in the way of the hot end assembly triggering the X limit switch. This is a replacement for the cover that comes with the printer - quite a bit more fiddly to install, however it keeps everything the same size so the X limit switch is fine, and doesn't slide about at all. 8/1/2021 Updated slightly to correct alignment of the PTFE tube clamp; was about 0.5mm out of alignment. Also added a variant with a slightly wider PTFE tube diameter for a looser fit.