Creality CR-10 V2 Cable Slides

thingiverse

Dangling calbes of the Creality CR-10 printers have always been a problem, especially the bed heating cable was always likely to get stuck at the corner of the bottom frame. Therefore I had alredy created a corner slide (simply replacing the 20x20 end cap of the frame) for my good old CR-10S some time ago. Now with the new CR-10V2 with generally better cable management but much longer cables I had the additional issue that sometimes the bed cable would fall into the middle of the frame when moving forward and then would ravel up under the frame when the bed moved backwards. Therefore I added a little ramp for the inside of the frame additionally to the corner slide cap. The CR-10V2 has higher feed than his predecessor, therefore ramp and the new corner slide will not fit an (unmodified) CR-10(S) version 1. The corder cap is therefore available in two variants, the ramp for the inside was not required for the version 1 because of the shorter cables. All pieces can be printed without support (the ramp lying flat, the little feet to the air) and can just be snapped into the 20x20/20x40 frame profile