Creality CR-10 Spool Holder Top Mount & Upright Filament Guide

cults3d

New and Improved Version V2 Now Available at the Following Link - (Released on February 1st, 2018) https://www.thingiverse.com/thing:2777687 A Critical Update Was Released on November 6th, 2017. Please See Part 2 Below. As Soon as I Got My Printer, I Raised the Platform to Make Room for the Controller Below It and Then Installed the Spool Holder on Top of the Bridge. Don't Worry About the Weight - the Frame is Extremely Rigid and Can Handle It. First, I Need to Talk About the Cone Lock. I Printed Mine with Support, Which Took Some Time to Remove Using a Twizzer. When Removing the Support, Make Sure Not to Leave Any Tolerance, or You Risk Having the Lock Spinning Together With the Spool and Locking it Up Completely. There Should Be a Bit of Resistance in the Thread. Next, I Want to Discuss the Filament Feeder V3 Guide. It's Recommended to Slot in the PTFE Tube for Smoothness. If You Print Without Support, You Won't Have Any Trouble Removing the Support from Inside the Tube. I Added a New Version (V3) on November 14th, 2017, Which Adds Strength and Supports the Tube. Please Re-Level After Installation. To Mount the Cylinder Spool Holder to the Spool Holder Bracket, Use the Following Screws: 2x M4 Short Spare Screws That Came with Your Printer 2x M4 Spare Stopper Screws That Came with Your Printer (or Purchase Here: https://go.edwardrc.com/2DS7EZZ) 2x M4 25cm Thread Length Screws 2x M4 Nuts or Lock Nuts Part 2 - After a Month of Using Version V2, I Experienced Two Occasions Where the Cone Lock Rotated With the Spool, Causing a Lock-Up. To Fix This Issue, I Added a Cone Lock Stopper and Included Installation Instructions. These Are Absolutely Necessary. To Install the Cone Lock Stopper, You Will Need: 2x M3 8mm Screws 1x M3 15mm Screw 1x M3 Lock Nut 1x M3 25mm or Any Other Length You May Have If You're Looking to Purchase a Creality CR-10 Printer, Click Here: http://bit.ly/2zB1Vlp