Creality CR-10 Spool Holder Top Mount & Upright Filament Guide

thingiverse

New Enhanced V2 Now Available Link Below, (February 1st, 2018) https://www.thingiverse.com/thing:2777687 *Critical Update on November 6th, 2017. See Part 2 Below* Right Away I Got the Printer, I Raised the Platform So I Can Put the Controller Below It, and Then the Spool Holder on Top of the Bridge(Don't Worry About the Weight, Frame is Very Rigid Enough) a. The Cone Lock, I Printed with Support, So It Took Some Time to Remove the Support with Twizzer, and You Gotta Make Sure That It's Not Too Loose Otherwise You Risk Having the Lock Spinning Together with the Spool and Locking It Up. Must Have a Bit of Resistance. Let Me Know If There's Any Issue with the Thread of the Cone Lock After Printed. b. The "Filament Feeder V3" Guide is Recommended to Slot in the PTFE Tube for Smoothness. *You Can Print Without Support So There's No Trouble of Removing Support from Inside the Tube* *November 14th, 2017 - Added V3 Which Supports the Tube, Adding Strength* *Please Redo Levelling After Installed* Mount the "Cylinder Spool Holder" to the "Spool Holder Bracket" with Screws Length as Below ***Screws Required, 2x M4 Short Spare Screw That Came with Printer (As Pictured) 2x M4 Spare Stopper That Came with Printer (or Purchase Here https://go.edwardrc.com/2DS7EZZ) 2x M4 25cm(Thread Length) Screw 2x M4 Nut or Lock Nut*** Part 2, After a Month of Using It, There Were Two Occasion Where the "Cone Lock" Rotates with the Spool, Causing Lock Up. So I've Added "Cone Lock Stopper" and Installation Instruction as Shown. *IT'S A MUST* Screws Needed 2x M3x8mm 1x M3x15mm 1x M3 Lock Nut 1x M3 25mm or As Long as You Have Where to Get Creality CR-10? http://bit.ly/2zB1Vlp